[Nov 30, 2021] 303 Dumps PDF and Test Engine Exam Questions - TestkingPass
Verified 303 exam dumps Q&As with Correct 525 Questions and Answers
NEW QUESTION 44
Refer to the exhibit.
The LTM devices LTM3 and LTM2 have four Traffic Groups defined with approximately the sar of failover objects defined in each group.
- Traffic Groups A and C have Default Device set to LTM1
- Traffic Groups Band D have Default Device set to LTM2.
- Traffic Groups B and C do NOT have Auto Failback enabled. TrafficGroups A and D have Auto Failback enabled with a timeout value of 60 seconds.
- Traffic Groups A and D have Auto Fallback enabled with a timeout value of 60 seconds.
Both LTM devices are healthy and able to pass traffic for any Traffic Group.
LTM1 loses connectivity on interface 1.4. The LTM Specialists notified 60 seconds after the interface goes down.
What is the state of the Traffic Groups on each LTM device?
- A. LTM1: No Traffic Groups
LTM2: Traffic Groups A, B, C, and D - B. LTM1: Traffic Groups A, B, C, and D
LTM2: No Traffic Groups - C. LTM1: Traffic Groups B and C
LTM2: Traffic Groups A and 0 - D. LTM1: Traffic Group C
LTM2: Traffic Groups A, B, and 0
Answer: A
Explanation:
Explanation
If the 1.4 port is down and failsafe is triggered, the whole machine will become a standby, and all Traffic Groups will be cut away, and no Traffic Group will remain.
NEW QUESTION 45
A BIG-IP Administrator wants to add a new Self IP to the BIG-IP device. Which item should be assigned to the new Self IP being configured?
- A. Trunk
- B. VLAN
- C. Interface
- D. Route
Answer: B
NEW QUESTION 46
AN LTM Specialist is setting up a new HTTPS virtual server to decrypt client traffic. SNAT the traffic and send the encrypted traffic to the poor member, the client's IP address must be included in the traffic sent to the pool member.
What is a complete set of profiles that must be configured for the virtual server to meet these requirements?
- A. TCP, Client SSL, HTTP
- B. TCP, Client SSL, Server SSL, HTTP
- C. TCP, Client SSL, Server SSL
- D. TCP , Server SSL, HTTP
Answer: B
NEW QUESTION 47
A custom TCP application using a single server is being migrated to the LTM device. A server is being added to the pool. The application is known to violate the TCP protocol RFC. Theapplication currently works without error from a user perspective.
Which virtual server type is appropriate in this situation?
- A. Performance (Layer 4)-pure layer A forwarding
- B. Stateless TCP protocol is not applicable
- C. forwarding (Layer 2) pure routingforwarding, pool cannot be specified
- D. Standard-tcp profile exists, RFC verification will be performed
Answer: A
NEW QUESTION 48
-- Exhibit -
-- Exhibit --
Refer to the exhibit.
An LTM Specialist is reviewing the virtual server configuration on an LTM device.
Which two actions should the LTM Specialist perform to minimize the virtual server configuration? (Choose two.)
- A. Remove 'snat automap' from the virtual server.
- B. Combine 'marketing_class' and 'default_class' into one class and update associations on the virtual server.
- C. Combine 'acct_class' and 'marketing_class' into one class and update associations on the virtual server.
- D. Remove the 'http' profile from the virtual server.
- E. Remove the 'default_class' from the virtual server.
Answer: C,E
NEW QUESTION 49
An ITM Specialist has the configuration shown:
The LTM Specialist needs to create a new virtual server in part B.
Which virtual address(es) should be used for the new virtual server?
- A. 10.90.0.1 and 10.12.0.1
- B. 10.120.0.1 only
- C. 10.90.0.1 and 10.100.0.1
- D. 10.100.0.1 and.10.120.0.1
Answer: D
NEW QUESTION 50
A BIG-IP Administrator explicitly creates a traffic group on a BIG-IP device.
Which two types of configuration objects can be associated with this traffic group? (Choose two.)
- A. VLANS
- B. Virtual Addresses
- C. iRules
- D. Pool Members
- E. Application Instances
Answer: B,E
NEW QUESTION 51
An LTM Specialist has recently taken over administration or an LTM devicethat has experienced resource availability issues. The LTM device will need to be solely used for load balancing and SSL offload.
Previously, the LTM device was also used to provide statistical analysis of application traffic. However, that functionality has been moved to a third party solution.
Based on the output below, which configuration change should be made to ensure the LTM module receives the most amount of resources?
- A. Provision AVR to Minimum, Provision LTM to Dedicated
- B. Provision LTM to Dedicated, Provision AVR to Dedicated
- C. Provision AVR to Minimum. Provision LTM at Maximum
- D. Provision AVR to none.Provision LTM to Dedicated
Answer: D
NEW QUESTION 52
To increase available bandwidth of an existing Trunk, the BIG-IP Administrator is adding additional interfaces.
Which command should the BIG-IP Administrator run from within bosh shell?
- A. tmsh create /net trunk trunk_A interfaces add {1.3.1.4}
- B. tmsh modify/sys trunk trunk^A interfaces add {1.3.1.4}
- C. tmsh create/sys trunk trunk_A interfaces add {1.3.1.4}
- D. tmsh modify /net trunk trunk_A interfaces add {1.3.1.4}
Answer: D
NEW QUESTION 53
An LTM Specialist needs to provide statistics regarding the round-trip time betweenthe clients and the servers.
Which metric should be part of the analytics profile to provide that information?
- A. Max TPS and Throughout
- B. Page Load Time
- C. Response Codes
- D. User Sessions
Answer: B
NEW QUESTION 54
An LTM Specialist needs to create two virtual servers.
The application has links for both HTTP and HTTPS version of application. The client must be persistence to a pool member, no matter which virtual server isaccessed.
What must be selected in the Source Address Affinity persistence profile?
- A. Match across Polls
- B. Match across Pool Members
- C. Match across Virtual Servers
- D. Match across Services
Answer: C
NEW QUESTION 55
Refer to the exhibit.
The http monitor is applied to a pool All members are enabled One pool member stops responding TCP port
80. The server still responds to ping.
What is the resulting status ofthis pool member?
- A. Unavailable (Disabled)
- B. Offline (Disabled)
- C. Unknown (Enabled)
- D. Available (Enabled)
Answer: D
NEW QUESTION 56
A BIG-IP Administrator needs to check the memory utilization on a BIG-IP system. Which two methods can the UIG IP Administrator use? (Choose two.)
- A. Run the tmsh show/sys memory command
- B. Run the tmsh show/sys traffic command
- C. Go to System > Disk Management in the configuration utility
- D. Go to Statistics > Module Statistics > Traffic Summary in the configuration utility
- E. Go to Statistics > Module Statistics > Memory in the configuration utility
Answer: A,E
NEW QUESTION 57
A BIG-IP Administrator uses a device group to share the workload and needs to perform service on a BIG-IP device currently active for a traffic group. The administrator needs to enable the traffic group to run on another BIG-IP device in the device group. What should the administrator do to meet the requirement?
- A. Select Traffic Group and then select Failover
- B. Select Traffic Group and then select Force to Standby
- C. Create a new Traffic Group and then fail to Standby Unit
- D. Select Traffic Group on Primary Unit and then select Demote
Answer: B
NEW QUESTION 58
Interface 1.2 on a BIG-IP VE has a status of UNINITIALIZED. What is the reason for this status?
- A. No default route has been created.
- B. Interface 1.2 has been disabled.
- C. Interface 1.2 has NOT been assigned to a VLAN.
- D. Interface 1.2 has been added to a trunk.
Answer: C
Explanation:
Explanation
trunk is a portchannel, you need to add a physical interface.
NEW QUESTION 59
......
F5 303 Test Engine PDF - All Free Dumps: https://www.testkingpass.com/303-testking-dumps.html
Get New 303 Certification – Valid Exam Dumps Questions: https://drive.google.com/open?id=1gAlb5qiZqOZvBOYnFEM9fZbvv1X1Cutx