Get Ready to Pass the JN0-250 exam with Juniper Latest Practice Exam [Q20-Q41]

Share

Get Ready to Pass the JN0-250 exam with Juniper Latest Practice Exam

Get Prepared for Your JN0-250 Exam With Actual Juniper Study Guide!

NEW QUESTION # 20
Which two statements are correct about Marvis? (Choose two.)

  • A. Marvis lets you ask questions about your network.
  • B. Marvis will send custom reports.
  • C. Marvis is the main configuration tool.
  • D. Marvis can be used as a proactive monitoring tool.

Answer: A,D


NEW QUESTION # 21
When would be the earliest opportunity to configure an access point (AP)?

  • A. after the AP is installed
  • B. after the AP is claimed to inventory
  • C. after you are on the same network as the AP
  • D. after the AP is online

Answer: A


NEW QUESTION # 22
You have discovered an access point that is not connected to the corporate network but it broadcasts the corporation's SSID.
In this scenario, what is this type of access point called?

  • A. rogue
  • B. honeypot
  • C. air gap
  • D. neighbor

Answer: A


NEW QUESTION # 23
Which two 802.11 amendments operate within the 2.4 GHz band? (Choose two.)

  • A. 802.11b
  • B. 802.11ax
  • C. 802.11a
  • D. 802.11ac

Answer: A,B


NEW QUESTION # 24
You have designed a WLAN to satisfy primary coverage, secondary coverage, and capacity requirements.
However, you still do not have enough BLE radios to satisfy your location requirements. You want to fill the gaps with a low cost, BLE-only device.
Which Mist device will satisfy this requirement?

  • A. AP32
  • B. AP43
  • C. BT11
  • D. AP41

Answer: C


NEW QUESTION # 25
Which Mist feature offers Al-based interactive troubleshooting?

  • A. Wireless Assurance
  • B. Insights
  • C. Marvis
  • D. Site Configuration

Answer: C


NEW QUESTION # 26
You have discovered an access point that is connected to a corporate network, but it is not under the corporation's control.
In this scenario, what is this type of access point called?

  • A. rogue
  • B. honeypot
  • C. air gap
  • D. neighbor

Answer: A


NEW QUESTION # 27
Which statement is correct about the Mist API?

  • A. Nothing seen in the GUI is available from the API.
  • B. Only AP configurations are available from the API.
  • C. Everything seen in the GUI is available from the API.
  • D. Only SLE configurations are available from the API.

Answer: B


NEW QUESTION # 28
A Mist access point is booting up, and will soon receive a channel assignment from the Mist Cloud. The channel assigned by the cloud is a DFS channel.
In this scenario, what must the AP do before broadcasting an SSID on the channel?

  • A. Transmit radar pulses for 60 seconds.
  • B. Validate client device support.
  • C. Validate available non-DFS channels.
  • D. Listen for radar.

Answer: D


NEW QUESTION # 29
Which statement is correct about a WLAN RF medium?

  • A. A WLAN RF is a full-duplex, contention-free medium where 802.11 stations can transmit and receive at the same time.
  • B. A WLAN RF is a half-duplex, shared medium where 802.11 stations contend with each other for access.
  • C. A WLAN RF is a half-duplex, contention-free medium where the access point polls each station in turn.
  • D. A WLAN RF is a full duplex, contention free medium where each client transmits on a separate channel.

Answer: B


NEW QUESTION # 30
You are troubleshooting a signal strength issue when you notice that the signal strength changes from -70 to
-73 dBm as you move from one room to another.
In this scenario, what is happening?

  • A. Signal strength has halved.
  • B. Signal strength has increased by 10x.
  • C. Signal strength has decreased by 10x.
  • D. Signal strength has doubled.

Answer: A


NEW QUESTION # 31
What does 802.11ac (Wi-Fi 5) specify as the maximum channel width?

  • A. 160 MHz
  • B. 20 MHz
  • C. 60 MHz
  • D. 40 MHz

Answer: A


NEW QUESTION # 32
Users are complaining about WLAN performance and the Mist dashboard reports non-Wi-Fi interference.
Which diagnostics tool would you use to further investigate this issue on-site and determine the location of the interference?

  • A. WLAN scanner
  • B. wireless design software
  • C. spectrum analyzer
  • D. protocol analyzer

Answer: C


NEW QUESTION # 33
Referring to the exhibit, what do you determine about the site's Time to Connect SLE metric?

  • A. All clients cannot connect to the Internet.
  • B. Time to Connect Association DHCP failures impacted 80% of users.
  • C. Successful connect averaged 1.6 seconds.
  • D. Eighty percent of the Time to Connect failures are related to DHCP failures

Answer: C


NEW QUESTION # 34
A microwave oven would be classified as which type of interference?

  • A. rogue
  • B. security
  • C. Wi-Fi
  • D. non Wi-Fi

Answer: C


NEW QUESTION # 35
A customer wants to physically wire their interior automated sliding doors to Mist APs to directly control location access to certain office areas.
In this scenario, which Mist AP capability allows them to accomplish this task?

  • A. header pins
  • B. optical sensor
  • C. IoT interface
  • D. audio sensor

Answer: A


NEW QUESTION # 36
Which underlying technology does Mist use to calculate BLE location?

  • A. time of flight
  • B. probability surface
  • C. trilateration
  • D. triangulation

Answer: B


NEW QUESTION # 37
You have just brought online a new site of AP43s. While verifying that everything looks good, you notice that all of the access points (APs) are reporting "insufficient power." The APs are connected to an 802. 3at-capable switch.
In this scenario, what would be the cause of the error?

  • A. The APs' firmware must be upgraded.
  • B. The Ethernet cable is plugged into the wrong port on the AP.
  • C. LLDP-MED is not configured on the switch.
  • D. The cable run to each AP is too long.

Answer: A


NEW QUESTION # 38
Which SLE would you use to determine Wi-Fi interference?

  • A. Capacity
  • B. Roaming
  • C. AP Uptime
  • D. Successful Connects

Answer: A


NEW QUESTION # 39
What are two characteristics of the 2.4 GHz band when compared to the 5 GHz band? (Choose two.)

  • A. shorter wavelength
  • B. lower frequency
  • C. more congestion
  • D. less non-Wi-Fi interference

Answer: B,C


NEW QUESTION # 40
Which two 802.11 amendments operate within the 2.4 GHz band? (Choose two.)

  • A. 802.11b
  • B. 802.11a
  • C. 802.11ax
  • D. 802.11ac

Answer: A,D


NEW QUESTION # 41
......

Pass Your Next JN0-250 Certification Exam Easily & Hassle Free: https://www.testkingpass.com/JN0-250-testking-dumps.html

Free Juniper JN0-250 Exam Question Practice Exams: https://drive.google.com/open?id=1JCyj1GQbcxbcrP7cydwadGaL33d9z2IB