[2025] Pass Huawei H12-323_V2.0 Premium Files Test Engine pdf - Free Dumps Collection
New 2025 Realistic H12-323_V2.0 Dumps Test Engine Exam Questions in here
NEW QUESTION # 360
In VRRP hot standby networking, in order to simplify the command line configuration of the standby WAC, you can enable the wireless configuration synchronization function. Through the wireless configuration synchronization function, the active VAC can use the HSB active-standby channel to synchronize the public wireless configuration to the standby WAC.
- A. True
- B. False
Answer: A
NEW QUESTION # 361
In the agile judgment distributed networking scenario consisting of the AirEngine series central AP and RU, the CAPWAP control tunnel between WAC and RU is composed of the CAPWAP control tunnel between WAC and central AP and the CAPWAP control tunnel between central AP and RU.
- A. True
- B. False
Answer: A
NEW QUESTION # 362
In a VLAN high-density stand scenario, which of the following are typical AP coverage methods?
(Multiple choice)
- A. Seat Coverage
- B. Edge Covering
- C. Edge + ceiling coverage
- D. Ceiling Covering
Answer: A,B,D
NEW QUESTION # 363
After a device fails, engineers will collect fault information, which mainly includes basic fault information, operating status information, device log information, and intelligent diagnostic information. Which of the following are the main contents of the operating status information?
(Multiple choice)
- A. System version
- B. Interface information
- C. Equipment Configuration
- D. Fault phenomenon
Answer: A,B
NEW QUESTION # 364
A large enterprise needs to deploy a WLAN network. In order to achieve secure isolation between employee access and guest access, the Navi AC networking architecture is adopted. At the same time, when the enterprise engineer configures user authentication, the security policy is set to Open. Which of the following cannot be selected when configuring the authentication method?
- A. MAC Authentication
- B. 802.1X authentication
- C. External Portal Authentication
- D. Built-in Portal authentication
Answer: B
NEW QUESTION # 365
In the Huawei terminal dial test solution, after the dial test is completed, the test results will be synchronized to the CampusInsight platform. You can log in to the CampusInsight platform to view the dial test results, which mainly include the following contents? (Multiple choice)
- A. Terminal signal strength, bandwidth, performance and other information
- B. Wireless signal name
- C. Signal strength trend
- D. Problem location process
Answer: A,B,C,D
NEW QUESTION # 366
As shown in the figure, in the N+1 backup networking scenario, WAC3 is configured with a global priority of 5, and WAC1 and WAC2 are configured with a global priority of 6 Configure AP1's personality priority as 3 on WAC1, and AP3's personality priority as 3 on WAC2. If WAC1, WAC2, and WAC3 are all unloaded, which WAC device will AP1, AP2, AP3, and AP4 connect to?
- A. AP1 accesses WAC1, AP2 accesses WAC1 or WAC2, AP3 accesses WAC2, and AP4 accesses WAC1 or WAC2
- B. AP1 accesses WAC2, AP2 accesses WAC1 or WAC2, AP3 accesses WAC1, AP4 accesses WAC1 or WAC2
- C. AP1 accesses WAC1, AP2 accesses WAC3, AP3 accesses WAC2, and AP4 accesses WAC3
- D. AP1 accesses WAC2, AP2 accesses WAC3, AP3 accesses WAC1, and AP4 accesses WAC3
Answer: C
NEW QUESTION # 367
An engineer is optimizing the wireless network on a customer's live network. He logs in to the device to check the network status as follows. What problem can be determined by the following command line echo?
- A. The terminal rate is too low. It is recommended to change the AP working protocol to Wi-Fi6.
- B. The AP channel utilization is too high. It is recommended to perform radio frequency tuning.
- C. The AP's two radio frequencies are unbalanced. It is recommended to enable the spectrum navigation function.
- D. The terminal signal strength is generally low, and there may be coverage issues
Answer: D
NEW QUESTION # 368
When using WLAN Planner for WLAN network planning, it supports functions such as merging, importing, exporting and sharing.
As shown in the figure below, if a user needs to share an existing project task with other engineers, which of the following user information can be entered in "Shared User"? (Multiple choice)
- A. Account
- B. Mobile phone number
- C. ID number
- D. Email
Answer: A,D
NEW QUESTION # 369
The engineer deployed a wireless environment in the customer's existing network. After completing the AP online and service configuration on the wireless controller, he used the terminal to associate the signal and found that the corresponding SSID could not be searched.
Which of the following is NOT the cause of this problem?
- A. AP power supply is insufficient
- B. The AP's radio frequencies are all turned off
- C. The test terminal does not support the currently configured country code
- D. The AP's working channel is a radar channel and needs to be silent for a period of time
Answer: D
NEW QUESTION # 370
Huawei's CampusInsight intelligent operation and maintenance platform collects data based on the SHMP protocol, ensuring that the experience of each user at all times is visible.
- A. False
- B. True
Answer: A
NEW QUESTION # 371
During the MAC authentication process, to prevent illegal users from brute-forcing the user name and password of the terminal, the silent function of MAC authentication can be enabled. By default, if a user fails to authenticate five times within 600 seconds, the access device will discard the user's authentication request within the next 60 seconds.
- A. False
- B. True
Answer: A
NEW QUESTION # 372
When the active/standby switchover occurs in a dual-link hot backup scenario, the switching time is long, which may cause interruption of service data forwarded by the tunnel or inability of new users to go online.
- A. True
- B. False
Answer: A
NEW QUESTION # 373
In a project, two points are 4.5 km apart. In order to transmit data between the two points, which of the following information do engineers need to collect? (Multiple choice)
- A. 2.4G channel usage between two points
- B. Obstacle information between two points
- C. 5G channel usage between two points
- D. Bandwidth requirements
- E. Terminal type
Answer: B,C,D
NEW QUESTION # 374
During the WLAN planning process, why is a site survey necessary?
- A. To analyze client behavior and application usage
- B. To monitor network traffic in real-time
- C. To configure security protocols for the network
- D. To identify and mitigate potential interference or coverage gaps
Answer: D
NEW QUESTION # 375
......
Updated Official licence for H12-323_V2.0 Certified by H12-323_V2.0 Dumps PDF: https://www.testkingpass.com/H12-323_V2.0-testking-dumps.html
Newly Released H12-323_V2.0 Dumps for Huawei-certification Certified: https://drive.google.com/open?id=195QQCqndjEWoir3frtXrvudXGLuX1zFf