2021 Easily pass H35-560 Exam with our Dumps & PDF Test Engine
H35-560 PDF Pass Leader, H35-560 Latest Real Test
NEW QUESTION 30
What is included in the detailed survey of the base station? (multiple choice)
- A. Base station location
- B. Antenna selection
- C. Determine at least 3 alternative sites
- D. Equipment installation location
- E. Computer room construction
Answer: A,B,D,E
NEW QUESTION 31
In an LTE network, an interface can be configured between eNODEB and MME. Which of the following is the interface name?
- A. S2
- B. X2
- C. X1
- D. S1
Answer: D
NEW QUESTION 32
For a dual-channel room with single polarization scenario, when antennas are deployed in a long and narrow corridor, in order to reduce antenna correlation, what is the relationship between the antenna spacing and the wavelength of the current frequency band?
- A. skyLine spacing is greater than2Times wavelong
- B. skyLine spacing is less than4Waveslong
- C. skyLine spacing is greater than4Waveslong
- D. skyLine spacing is greater than10Waveslong
Answer: C
NEW QUESTION 33
Which of the following results can be reported in the Measurement Report? (Multiple choice)
- A. SINR
- B. RSRQ
- C. RSSI
- D. RSRP
Answer: B,D
NEW QUESTION 34
Single-site verification refers to the self-inspection and verification of the equipment functions and coverage capabilities of a single-site after the eNB hardware installation and debugging are completed.
- A. True
- B. False
Answer: A
NEW QUESTION 35
Which of the following functions is used for inter-cell interference coordination?
- A. AMR
- B. ANR
- C. BF
- D. ICIC
Answer: D
NEW QUESTION 36
There are 503 PCI physical cell identifiers.
- A. True
- B. False
Answer: B
NEW QUESTION 37
The drive test scenario judges the success of the handover, usually based on the signaling. On the terminal side, which of the following signaling starts the handover process?
- A. Handover Request
- B. Handover Command
- C. Measurement Report
- D. Measurement Control
Answer: C
NEW QUESTION 38
What are the evaluation methods for overlapping coverage issues? (Multiple choice)
- A. The number of cells with RSRP>-100dBm is greater than or equal to 2.
- B. The number of cells with RSRP>-100dBm is greater than or equal to 3.
- C. RSRP of the strongest cell-RSRP of the 3rd strongest (or 4th strongest) cell<6dBo
- D. RSRP of the strongest cell-RSRP of the 3rd strongest (or 4th strongest) cell<3dBo
Answer: B,C
NEW QUESTION 39
Which of the following descriptions are correct for cross-zone coverage? (Multiple choice)
- A. Cross-area coverage may cause UE transmit power limitation, causing access failure
- B. For LTE, cross-area coverage will not cause interference to its neighboring cells
- C. Cross-area coverage may result in unbalanced load between the cross-covered base station and surrounding base stations, resulting in low resource utilization of surrounding base stations
- D. Over-area coverage may form "islands", leading to dropped calls
Answer: A,C,D
NEW QUESTION 40
Regarding indoor distribution antennas and components, which of the following statement is wrong?
- A. Power splitter: Split one signal into two or more channels (three-way, four-way) output
- B. The leaky cable can be regarded as a kind of slot antenna, suitable for coverage in tunnels, subways, etc.
- C. Attenuator: consuming the excessive energy of RF signal, mainly used to reduce signal level and avoid the influence of overflow
- D. Try to use "high power, less antenna" for indoor antenna layoutcorrect
Answer: D
NEW QUESTION 41
Which signaling is triggered by the statistics of the number of successful establishments of the RRC connection establishment?
- A. RRC connection setup
- B. RRC connection setup complete
- C. RRC connection reconfiguration complete
- D. RRC connection request
Answer: B
NEW QUESTION 42
The reason values for LTE RRC establishment include: emergency calk h ig h Priority Access x mt-Access mo-Singnalling and mo-Data.
- A. True
- B. False
Answer: A
NEW QUESTION 43
LTE power control does not affect the coverage and capacity of the system.
- A. True
- B. False
Answer: B
NEW QUESTION 44
Which of the following factors are the base station receiver sensitivity related to? (multiple choice)
- A. Base station noise figure
- B. Cell radius
- C. untieThreshold
- D. channelbandwidth
Answer: A,C,D
NEW QUESTION 45
The SINR of each codeword can be obtained through the Probe drive test tool, and the higher the SINR, the better.
- A. True
- B. False
Answer: A
NEW QUESTION 46
Regarding the over-zone, overlapping coverage control, which of the following statements is wrong?
- A. Topological structure planning: the site distribution is as uniform as possible
- B. Station spacing control: strictly avoid overlapping coverage sites within 100m
- C. Station height control: strictly control the station height to avoid over-zone interference
- D. The angle of the sector in the station should be kept as close as possible to 60 degrees, direct sparring between stations can enhance coverage
Answer: D
NEW QUESTION 47
Which of the following adjustment measures has the highest priority?
- A. Antenna height
- B. Antenna type
- C. Antenna direction angle antenna downtilt angle
Answer: B
NEW QUESTION 48
The insertion loss of the cavity power divider is larger than that of the microstrip power divider.
- A. True
- B. False
Answer: B
NEW QUESTION 49
Which of the following information can be observed directly through the Probe drive test tool? (Multiple choice)
- A. Number of occupied carrierscorrect
- B. PUSCH, PUCCH, RACH, and sRS physical channel transmit powercorrect
- C. UE real-time transmit power
- D. TM modecorrect
Answer: A,B,D
NEW QUESTION 50
The single-station verification test only needs to verify whether the cell status in the idle mode is normal.
- A. True
- B. False
Answer: B
NEW QUESTION 51
In the process of LTE network optimization, which of the following data sources are used for problem location analysis? (multiple choice)
- A. Signaling data
- B. useUser complaint record
- C. Project Files
- D. netNetwork test data
- E. Traffic statistics and alarm data
Answer: A,B,D,E
NEW QUESTION 52
......
H35-560 Dumps Ensure Your Passing: https://www.testkingpass.com/H35-560-testking-dumps.html